Millipore Milli-Q Plus Manuel d'utilisateur télécharger pdf (Page 9)

INTRODUCTION

Milli-Q Academic / Academic A10 1

Chapter 1 INTRODUCTION

1-1 USING THIS MANUAL

MATCHING THIS MANUAL WITH YOUR MILLI-Q



This manual is intended for use with a Millipore Milli-Q Academic or Academic A10 Water

Purification System.

This User Manual is a guide for use during the installation, normal operation and maintenance of a Milli-Q

Academic or Milli-Q Academic A10 Water Purification System. It is highly recommended to completely read this

manual and to fully comprehend its contents before attempting installation, normal operation or maintenance of the

Water Purification System.

You can easily identify your type of Water Purification System if you do not see the Catalogue Number. The Milli-Q

Academic and Academic A10 Water Purification Systems have a Blue Door on the front cabinet.

If this manual is not the correct one for your Water Purification System, then please contact Millipore.

HOW TO USE THE KEYPAD AND THE LCD

The Keypad and LCD (liquid crystal display) are located on the front of the Water System Cabinet.

The Keypad buttons sometimes have a slight delay when pressed. As an example, suppose you want to change the

Milli-Q from STANDBY Mode to PRE OPERATE Mode. This is done by pressing the OPERATE/STANDBY Keypad

button for about two seconds.

There are four Keypad buttons. These are labelled as OPERATE/STANDBY, MEASURE, CLEANING and MENU.

See the drawing above for their placement.

The LCD is a backlit, dual line 16-character display.

The LEDs are located to the right of the LCD (see above). The POWER LED is green. This is lit when the Water

System microprocessor has electrical power. The SERVICE LED is yellow. This will flash when a service type of LCD

message is displayed (i.e. EXCH. CARTRIDGES. is shown, meaning to change the cartridges in the system). The

ALARM LED is red. This will flash when an alarm condition is indicated on the LCD (i.e. PAK NOT IN PLACE,

meaning a purification pack is not fully in place or is absent).

OPERATE / STANDBY

MEASURE

CLEANING

POWER

SER

ICE

LAR

PRE OPERATE

OPERATE / STANDBY

MEASURE

CLEANING

POWER

SERVICE

LARM

S T A ND B Y

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 92 93

Commentaires sur ces manuels

Pas de commentaire

Millipore Milli-Q Plus Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Distributeurs d'eau Millipore Milli-Q Plus