Millipore Milli-Q Plus Manuel d'utilisateur télécharger pdf (Page 22)

PRE INSTALLATION

Milli-Q Academic / Academic A10 14

Chapter 3 PRE INSTALLATION

3-1 PRE INSTALLATION CHECKLIST

The installation of your Milli-Q will go much easier if certain pre installation requirements are met and followed.

The checklist below can be used to facilitate the pre installation of your Milli-Q System. You can refer back to this

checklist as you read the sections on Optional Equipment, Installation Requirements and Unpacking the Milli-Q Box.

 Do you have a Q-Gard Purification Pack?

 Do you have a Quantum Ultrapure Cartridge?

 Do you have a Millipak?

or BioPak?

 Do you have a Milli-Q and all items in its Accessories Bag?

 Do you have a source of electrical power close enough to the Milli-Q?

 Is the electrical source Earth Grounded?

 Are you feeding with a Reservoir? (if feeding from a pressurised pipe, see below)

 Is the reservoir full of water?

 Is the source of water filling the reservoir fully operational?

 Does the reservoir have an 8 mm tubing connection on one of its valves?

 Are you feeding the Milli-Q from a pressurised pipe (loop)?

 Do you have a Pressure Regulator ready to connect between the pipe and the Milli-Q?

 Is the water system feeding the pipe fully operational?

 Does the pipe have a valve ending with a 1/2 inch NPTM connection? If not, do you have a fitting or

connection that will attach to the pipe and will end in a 1/2 inch NPTM connection?

 Is there a way to shut off water from the pipe to the Milli-Q? If not, did you order a Ball Valve from

Millipore to install on the feedwater tubing?

 Are you mounting the Milli-Q on a wall?

 Do you have a Wall Mounting Bracket?

 Will the wall support the weight of the Milli-Q (plus full reservoir,...)?

 Is the Milli-Q accessible at this height (viewing the LCD, using the Keypad)?

 Did you include space on the right side of the Milli-Q to remove and replace the Q-Gard?

 Did you want a location so as to dispense water over a sink?

 Is the Milli-Q located within 2.5 meters of a drain (for the Feedwater Pressure Relief Valve tubing)?

 Are the room environmental conditions adequate (humidity, temperature)?

 If you are going to connect a printer or computer to the Milli-Q later, did you leave room for this?

 If you are using a footswitch accessory to control the Milli-Q, did you leave room for this?

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 92 93

Pas de commentaire

Millipore Milli-Q Plus Manuel d'utilisateur Page 22